How to install

INTERIOR FRAMING INSTALLATION

Step 1: Secure the anchors using a minimum of 2 screws each approximately 2 to 6 inches from the ends. Make sure to upgrade properly for best result. If your order contains more than 2 anchors, be sure to install them in the middle of your interior framing, ensuring that the spaces between the anchors are proportional.

Step 2: Insert the blind tip at each end until you hear a “click”, confirming that your canvas is properly installed.

EXTERIOR FRAMING INSTALLATION

Step 1: Attach the supports to the exterior framing or to the location where the measurement was previously taken. Place these so that they are all aligned to make it easier to attach your blind later. It is important to make sure to position the anchors close to the ends (2 to 6 inches) in order to better support your blind.

Step 2: Insert the white part of the anchor into the front part of the cassette. Then push the rear part of your awning cassette onto the rear part of the support until you hear a “click”, confirming that your fabric is properly installed.